The one question I have is all of the other boards have pin out diagrams (Mini/Remix) but no diagram for the Full Sized board. Now with LightBurn and C3D I can directly control it from my Mac rather than the strange combination of a Windows PC with K40Whisper, Drop Box and Team viewer I was using and hour ago. The only snag (literally) was the cord for the end stops needed to be tugged a bit to actually reach the spot on the C3D board. Is there some way I can calibrate the axis in the software or is there a setting that I am not aware of? Any help would be greatly appreciated. All vertical dimensions are about 15% too large. I found that the Y axis is well out of calibration. Installation went without a hitch and everything seemed to work well until I started doing some serious projects. I have just installed the C3D laser board in my K40 laser. I have just installed the C3D laser board in my K40 laser So I just got my LaserBoard in the mail, however I have 1 question… So I just got my LaserBoard in the mail, however I have 1 question. Simple question i cannot seem to google the answer to: Does the cohesion mini run on 12v aswell ? i have external stepper drivers so i dont really need 24v. Simple question i cannot seem to google the answer to: Does the cohesion mini run on 12v aswell ?

Cohesion3d